Closed Cell Efficiency.

Formed from thousands of independetly water resistant cells, FEF and PEF insulation is naturally resistant to moisture ingress and requires no additional water vapour barrier.

Energy Efficiency with Closed Cell Insulation

The design goal is to keep the surface temperature above the dew-point temperature of the surrounding air. Calculating surface temperature is relatively simple, but selection of the appropriate design conditions is often confusing. The appropriate design condition is normally the "worst case" condition expected for the application. For condensation control, however, a design that satisfies the worst-case condition is sometimes impossible.

Image

Closed Cell Efficiency

Note that the discussion here has focused so far on designing to avoid condensation on the exposed surface. Another important design consideration is minimizing or managing water vapour intrusion.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.

Closed Cell Efficiency

Note that the discussion here has focused so far on designing to avoid condensation on the exposed surface. Another important design consideration is minimizing or managing water vapour intrusion.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.
Image

Condensation Control Box

Mechanical insulation is primarily used to limit heat gain or loss from surfaces operating at temperatures above or below ambient temperature. Mechanical insulation may be used to satisfy one or more design objectives.

Mind the gap

Application is key to save energy and resources when insulating mechanical systems. With FEF and PEF this is easily to achieve without hate use of special tools. Its flexible nature and xxxxx. xxxx demonstrating best practice for pipe and duct insulation for both renovation (retro-fitting) and new build systems.

Image

Just a few cuts away

Insulating bends professionally with FEF and PEF tube.
Image

Just a few cuts away

Insulating bends professionally with FEF and PEF tube.
Image

Just a few cuts away

Insulating bends professionally with FEF and PEF tube.
For specific application guidelines and advise visit member information by clicking on the logos below.